Plating Speed
Chemical bath mass transfer kinetics determine the thickness accumulation of metallic plating per unit time within substrate microvias. Wet chemical process parameters directly dictate copper deposition rate during electroless or electrolytic plating cycles. Bath agitation speed and copper ion concentration determine bath throughput capacity.
Uniformity requirements bound the acceptable speed range across panel surfaces.
Mass Transfer
Diffusion limits within narrow blind microvias impede continuous reagent exchange at the target surface. Cathode current density drives ion migration in electrolytic cells while bath circulation forces fresh solution into deep cavities. High current density increases nominal plating speed but risks burning outer panel edges where current concentration peaks.
Fluid boundary layers inside microvias retard mass transport, causing thinner copper deposits at the bottom than on surface capture pads. Pulse periodic reverse plating alters deposition behavior by alternating cathodic and anodic cycles to balance copper distribution across complex geometries. Substrate surface roughness affects initial nucleation density during early deposition phases.
Process controls maintain ion concentration and temperature within tight windows to sustain target deposition velocity.
Thickness Tolerance
Cross-sectional X-ray fluorescence measurement verifies compliance with IPC-6012 thickness standards. Sub-optimal plating velocity leads to thin wall coverage and early via failure. Excessive copper deposition rate causes plating nodules and non-uniform surface distribution across dense trace arrays.