Metal Foundation
Thin metallic coatings provide the initial conductive path required for subsequent electrolytic plating on non-conductive substrates. The copper seed layer acts as the base upon which thicker traces and via walls are built during the board fabrication process. It covers the entire surface of the laminate and the interior walls of drilled holes.
Deposition Method
Electroless plating or physical vapor deposition creates the primary film on the epoxy resin. A copper seed layer typically measures between 0.5 and 1.5 microns in thickness. The process begins with a catalyst, often palladium, which prepares the surface for the chemical reduction of copper ions.
If the deposition is uneven, the following electrolytic step will exhibit voids or thin spots in the circuit pattern.
Adhesion Performance
Mechanical bonding between the polymer and the metal determines the long-term reliability of the interconnects. The copper seed layer must resist delamination during the thermal stress of soldering. Roughening the substrate via plasma or chemical means improves the physical interlocking at the interface.
Micro-etching removes the seed layer from non-circuit areas after the main traces are plated to prevent electrical leakage. Stable bonding at this stage prevents the formation of cracks during field operation.