Conductor Mass
Areal mass classification for foil cladding dictates the nominal thickness of internal conductive traces on multilayer printed circuit board cores. Standard inner layer copper weight options range from half ounce per square foot up to three ounces per square foot, corresponding to nominal foil thicknesses between 18 and 105 micrometers. Selecting conductor mass establishes current carrying capacity and thermal dissipation capability within embedded circuit layers.
Substrate selection depends heavily on this metric to ensure adequate resin flow during lamination.
Encapsulation Requirement
Thicker copper foil creates higher relief profiles on core surfaces that require increased resin volume during vacuum lamination. Higher inner layer copper weight demands prepreg styles with higher resin content to fill step height clearances between adjacent signal lines without forming resin voids. Insufficient resin volume over heavy copper features leads to internal lamination voids or localized dielectric thinning over trace tops.
Thermal press cycles must provide sufficient low viscosity dwell time to allow resin migration into deep copper channels.
Etch Resistance
Trace width reduction during chemical etching scales directly with starting foil thickness. Heavier inner layer copper weight requires longer exposure to chemical etchants, increasing undercut side etching and limiting minimum line spacing features.