Geometric Defect
Localized reduction of electroplated copper thickness occurring at the corner transition between a printed circuit board surface and a drilled through-hole wall represents a standard fabrication vulnerability. Metallurgical laboratories identify knee thinning when copper deposits at this ninety-degree junction measure less than the required nominal barrel wall thickness. The defect classification applies specifically to the curved shoulder zone and ceases to govern the flat surface foil or the central through-hole barrel.
Deficient plating at this junction creates a stress concentrator during thermal shock.
Electrochemical Distribution
Hydrodynamic mass transfer variations inside plating cells cause current density disparities between outer panel faces and recessed hole interiors. Plating current concentrates naturally at outer edges, but poor electrolyte circulation or excessive organic leveling additives suppress deposition along the abrupt entrance geometry. Low throwing power in acidic copper sulfate baths further starves the hole corner of cupric ions while fluid shears rapidly across the surface.
When cathode agitation fails to exchange electrolyte within narrow via barrels, deposition efficiency collapses at the entrance radius. Automated fluid agitation mechanisms mitigate this imbalance by forcing fresh chemistry through hole cavities.
Acceptance Threshold
Microsection analysis performed after thermal stress testing determines whether corner copper meets IPC-6012 Class 3 minimum criteria. Cross-sections revealing thickness below specified thresholds trigger panel scrap due to post-assembly barrel separation risks.