Soldering Defect
Solder paste bridging occurs when a continuous conductive path forms between two or more adjacent pads or traces on a printed circuit board. This condition happens when excess solder paste overflows the stencil aperture or fails to maintain shape during the reflow heating cycle. Liquid metal surface tension pulls the molten alloy across the mask opening, creating an unintentional electrical link.
Shorts caused by this phenomenon prevent the board from functioning according to the intended circuit logic. Inspection systems detect the connection through optical checks or electrical continuity tests performed after the cooling phase.
Manufacturing Variable
Precise alignment between the stencil and the copper pads governs the amount of material deposited onto the surface. When the stencil sits slightly offset, paste squishes out from under the metal foil during the printing stroke. Excessive squeegee pressure or incorrect snap off height also forces solder into regions where the design prohibits metal.
Heat ramp profiles influence the viscosity of the flux, and a rapid increase in temperature before the volatile components escape causes the paste to slump. Adjusting the squeegee speed or the pressure settings stabilizes the deposit geometry and limits the risk of overflow.
Reliability Impact
Electrical failure follows when a bridge creates a low resistance path between nets that should remain isolated. Unwanted currents flowing through the shorted connection produce heat, which damages sensitive components or causes local board charring. Faulty boards identified during testing generally require manual rework to remove the excess metal.
Automated repair processes prove difficult due to the confined space between fine pitch components. Reliability over the service life of the device depends upon the total removal of all such links during the initial fabrication stage.