Current Flow
High-frequency signals in printed circuit boards do not travel uniformly through the entire cross-section of a trace. The surface current distribution describes how electrical current concentrates on the outer skin of the copper conductor. This behavior is caused by the skin effect at high frequencies.
It increases the effective resistance of the trace.
Trace Geometry
Sharp corners and narrow track widths can cause localized increases in current density. These areas are prone to increased heating and impedance changes. Rounded bends and uniform trace profiles help to maintain a more balanced current flow across the circuit.
Measurement Method
Engineers use specialized near-field probes to scan the board and map the magnetic field generated by these currents. This diagnostic step helps locate hot spots and verify that return currents are following their intended ground planes. When a return path is interrupted by a slot in the ground plane, the current must detour around the obstruction.
This detour increases the inductance and can generate electromagnetic emission problems. Analyzing these paths allows designers to modify the copper layout to improve signal performance. Furthermore, high-frequency simulation tools are used to predict these distributions during the design phase to avoid expensive board revisions.