Adhesive Cohesion
Mechanical holding force quantifies the peak tensile load an unreflowed solder paste deposit withstands before separating from a test probe or inserted component lead. Electronics assembly facilities evaluate this mechanical adhesion to ensure surface-mount components remain stable on wet paste prints between placement and thermal reflow. Test apparatus governed by standard IPC-TM-650 Method 2.4.44 drives a polished stainless steel probe into a printed paste deposit, measuring the maximum extraction force required to pull the probe free after a set dwell period.
The parameter applies strictly to wet solder paste in its green state, ceasing once the reflow oven melts the metallic particles into rigid solder joints.
Component Retention
Automated pick-and-place systems operate at rapid speeds, generating high table accelerations that dislodge components lacking adequate base adhesion. Adequate tack strength holds tiny passive components and heavy silicon packages stationary while conveyors transfer panels across factory workstations. The flux vehicle provides this retention through its balance of sticky rosins, tackifying resins, and non-volatile plasticizers.
Inadequate tack allows components to drift off target pads, causing skew, bridging, or open connections upon entering reflow heating zones.
Shelf Decay
Paste exposure to shop air degrades holding strength over operational time through solvent evaporation and moisture absorption. Line managers track open tack life to establish maximum permissible hold times between printing and reflow phases. Tack testing machines chart load retention across eight-hour windows, revealing drying curves that signal the onset of paste degradation.
Pastes failing retention requirements are scraped off boards, because compromised adhesion allows parts to shake loose during transit into reflow furnaces. Stable mechanical retention prevents placement defects, tombstoning, and alignment loss on fast surface mount assembly lines.