Process Duration
Thermal bonding of flexible circuits to rigid substrates requires holding the adhesive joint under a controlled pressure and temperature for a specified period. This duration is defined as heat seal dwell and ensures that the thermoplastic or thermosetting adhesive flows into the microscopic surface roughness of the mating pads. Selecting the correct time prevents under-cured joints that can detach under mechanical load or over-cured joints that suffer from thermal degradation.
Adhesive Activation
Adhesive flow begins as the heating element applies pressure, forcing the resin to melt and wet the metal contacts. If the contact time is too brief, the adhesive does not reach its activation temperature throughout the bond area, resulting in weak joints and high contact resistance. Conversely, excessive duration can cause the adhesive to squeeze out of the joint, leading to short circuits or depleted bond lines.
Precise timing must be maintained to achieve optimal mechanical and electrical performance.
Bond Evaluation
Peel strength testing verifies the quality of the thermal bond after the dwell phase is complete. This test involves pulling the flexible circuit at a right angle to measure the force required for separation. When the parameter is set correctly, the failure mode is cohesive rather than adhesive.