Physical Isolation
Precision-milled pockets within a circuit board or metal enclosure serve to isolate radio frequency components and prevent internal interference. Designers use a high frequency cavity to enclose oscillators or power amplifiers that might otherwise couple energy into nearby traces. These structures are often plated with copper or gold to provide a highly conductive internal surface.
Resonance Control
Separation of circuit stages within a single assembly prevents unwanted feedback and improves the signal to noise ratio. Walls of the cavity act as a grounded barrier that absorbs or reflects stray waves.
Fabrication Requirement
Machining these features requires controlled depth milling to ensure the remaining floor of the cavity provides sufficient mechanical strength. In multi-layer boards, the high frequency cavity may expose internal ground planes that act as the floor of the shielded area. Automated routing equipment maintains tight tolerances to ensure the cavity matches the dimensions of the component or the shield lid.
Surface roughness inside the milled area must be minimized to avoid scattering of electromagnetic waves. Inspection involves measuring the depth and width with laser micrometers to ensure the resonant properties remain consistent across production lots. Alignment between the cavity and the associated solder pads is necessary for reliable assembly of surface mount components.