Thermal Requirement
Heat transfer requirements increase considerably when joining components with large physical dimensions or high metal content to a circuit board. Successful high mass soldering depends on the ability of the equipment to deliver a consistent and sustained volume of heat to the joint area. This process often involves longer soak times in the reflow oven to allow the internal temperature of the large components to equalize with the surface of the board.
Energy Transfer
Convection heating is the primary method used to overcome the resistance of large parts to temperature changes. Higher air velocities and optimized nozzle designs ensure that the heat reaches the underside of components and into deep cavities. During high mass soldering, the risk of a temperature lag between the board surface and the component lead is high, which can result in poor wetting.
To counter this, the reflow profile is stretched, providing a gradual ramp that prevents thermal shock while ensuring the thickest sections of the assembly reach the required liquidus temperature. Specialized fixtures may also be employed to provide additional heat through conduction from the bottom side of the pallet.
Quality Inspection
Solder joints on high mass parts are prone to voids because of the longer time the alloy stays in a liquid state. X-ray inspection is frequently used to verify the internal integrity of these connections. Ensuring a full fillet on a large terminal requires precise control over the paste volume and the thermal ramp.