Residual Charge
Residual electrical signals from previous frames degrade the temporal contrast of real-time imaging systems by carrying old exposure data into new frames. Unwanted image lag occurs when the charge carrier collection in a detector photodiode is slow or incomplete, leaving a ghost image behind. The problem is particularly noticeable during dynamic testing of moving circuit boards, where it produces motion blur and decreases the accuracy of defect detection.
Minimizing the trap density in the silicon helps to clear the charge quickly between readout cycles.
Pixel Architecture
Advanced pixel design incorporates pinned photodiodes to reduce the trapping of charge carriers at the silicon dioxide interface. Transferring the signal from the photodiode to the floating diffusion node occurs more efficiently in these structured pixels. This transfer reduces the residual charge that would otherwise persist into the next integration period.
Operating the sensor at lower frame rates can also reduce the impact of this phenomenon by allowing more time for the carriers to recombine or be collected.
Frame Speed
Fast conveyor systems require rapid frame acquisition to inspect electronics without stopping the production line. If the ghost image is too strong, the inspection algorithm can misinterpret the blended frames and reject acceptable assemblies. This issue is resolved by utilizing high-performance sensors with low capacitance nodes.