Subtractive Chemical Etch
Unintended horizontal metal removal beneath the protective photoresist mask edge occurs concurrently with intended vertical chemical dissolution during printed circuit board fabrication. As liquid lixiviants attack the exposed surface foil, lateral dissolution progresses underneath the patterned dry film boundaries, eroding the top shoulder of the defining copper trace. This process phenomenon establishes the fundamental chemical limit of subtractive manufacturing, losing relevance in additive processes where conductor walls are built by electrodeposition within resist channels.
Anisotropic Reaction Kinetics
Reaction chemistry relies on chemical impingement momentum to bias the vertical dissolution vector over the stagnant horizontal rate. When etchant solution contacts copper surfaces, lateral dissolution is driven by isotropic concentration gradients beneath the photoresist overhang, resulting in an undercut region. The magnitude of this horizontal loss divided by the downward etch depth defines the etch factor of the finished conductor.
In horizontal spray systems, spend chemistry trapped under the film edge sustains localized dissolution even after fluid flow passes, producing trapezoidal conductor cross-sections with narrower tops than bases. Formulations containing specific chemical additives such as nitrogenous organic compounds adsorb onto trace sidewalls to chemically suppress horizontal copper chelation without retarding vertical strike rates.
Sidewall Profile Verification
Destructive microsection inspection per IPC-TM-650 Method 2.1.1 prepares cross-sectional specimens to observe conductor geometries under optical or scanning electron microscopes. Inspectors measure nominal base width, upper trace width, and undercut depth to verify conformance with specified conductor clearance minimums. Over-etching caused by excessive horizontal attack reduces the final trace cross-sectional area, creating localized hot spots and shifts in characteristic line impedance.
Etch-compensation factors applied to production CAD artwork must match the measured rate of lateral attack precisely.