Interfacial Separation Mode
Mechanical separation between electrodeposited copper microvia walls and underlying target landing pads represents a primary reliability defect in high-density interconnect circuit boards. Physical stress concentrated at the via base during thermal cycling causes adhesion failure across the metallic interface. Microvia interfacial delamination occurs when the bond between target pad plating and plated via wall fails, creating an open circuit or intermittent electrical connection.
Scanning acoustic microscopy catches this planar defect by detecting acoustic phase inversion across the separated interface.
Thermal Strain Behavior
Z-axis thermal expansion of epoxy glass substrate materials generates strong vertical tensile force on microvia structures during reflow soldering. Epoxy matrix resin expands at roughly four times the rate of copper plating along the vertical axis, creating severe shearing stress at the flat target pad contact surface. Chemical residues left on landing pads prior to copper electroplating weaken interfacial bonding strength and accelerate delamination under thermal stress.
As thermal cycles repeat, micro-cracks propagate across the target pad contact surface until complete metallic separation occurs. Acoustic inspection identifies these flat planar separations by evaluating the phase reversal of ultrasonic energy reflected from the unbonded copper boundary.
Quality Acceptance Limit
Post-assembly reliability standards require zero microvia separation across all interconnect layers following multiple thermal shock cycles. Boards displaying acoustic reflection shifts at target pads face immediate rejection.