Gaseous Entrapment
High-pressure lamination must eliminate all air and volatile gases from the laminate stack to ensure a solid dielectric barrier. The initiation of microvoid formation arises when microscopic air pockets are trapped within the liquified prepreg during board lamination. These cavities are often located at the glass yarn crossings or along the copper boundaries where the flowing resin cannot easily reach.
If left unchecked, these voids weaken the electrical insulation of the board.
Solvent Volatilization
Moister prepreg materials and residual solvents are the primary sources of trapped gases during the heating cycle. To prevent microvoid formation, prepregs must be stored in humidity-controlled chambers to limit moisture absorption before layup. When the temperature ramps up, trapped water or solvent residues vaporize and form high-pressure bubbles in the curing epoxy.
Raising the vacuum level during the early stages of lamination extracts these vapors before the resin hardens.
Reliability Failure
Printed circuit boards that harbor internal voids are vulnerable to conductive anodic filament growth when subjected to electrical bias in humid environments. The hollow spaces created by microvoid formation act as pathways for copper ion migration across the dielectric layer. Over time, these conductive filaments bridge the gap between opposing traces, causing sudden short circuits and catastrophic board failure.
Furthermore, these cavities expand during assembly reflow, putting stress on plated copper holes and causing via barrel cracks. Fabricators detect these voids through scanning acoustic microscopy or cross-sectional analysis during quality control audits.