Adhesion Loss
Adhesive failure occurs when a conductive copper pad detaches from the underlying laminate or solder mask. Excessive heat or mechanical force usually triggers pad lifting during the assembly or rework of a circuit board. This defect breaks the electrical connection between the component lead and the circuit trace.
While the pad remains attached to the component, the bond to the substrate fails completely.
Failure Driver
Manual soldering at high temperatures often degrades the adhesive bond between the copper foil and the resin. If a technician applies pressure with a soldering iron tip for too long, the local resin softens beyond its glass transition point. Heavy components or rigid connectors can also pull pads away from the surface during vibration or drop testing.
Poor moisture control before reflow leads to outgassing that pushes the pad upward.
Mitigation Strategy
Designers increase the durability of the layout by adding anchor spurs or teardrops to the pads. These features provide more surface area for the copper to grip the laminate. Using materials with a higher glass transition temperature provides a greater safety margin during the assembly process.
Proper storage in dry cabinets prevents the absorption of water that leads to internal pressure during heating. Rigid support fixtures during handling prevent the board from flexing enough to pop the pads loose.