Gas Emission
Rapid evaporation of volatile liquids from the solder paste or board laminate during heating releases gas into the surrounding environment. While most of this movement is expected, solvent outgassing becomes a problem when the gas is trapped inside the molten solder or beneath a component body. This phenomenon occurs as the assembly moves through the preheat and reflow zones.
It is a major factor in the creation of structural defects.
Void Formation
Trapped bubbles of gas result in internal voids within the solder joints, which can reduce the mechanical strength and electrical conductivity of the connection. If the temperature rises too quickly, the volume of gas produced by solvent outgassing exceeds the ability of the paste to vent it. This pressure can cause solder to eject from the joint, creating solder balls or beads on the board surface.
In some cases, the gas can even lift small components off their pads, a defect known as the tombstone effect. Proper profiling with a steady preheat allows these vapors to escape before the solder reaches its liquidus state.
Residue Prevention
Effective ventilation in the reflow oven removes these gases from the process chamber to prevent contamination of the heating environment. This prevents the vapors from condensing back onto the cool boards.