Wave Termination
Passive impedance matching network designs evaluated against line characteristic impedance eliminate signal voltage reflections at high-speed board interconnect terminals. Connecting a termination resistor across or in line with a high-speed transmission trace absorbs reflected wave energy to maintain eye diagram symmetry. Impedance matching values correspond to trace characteristic impedance, typically fifty ohms for single-ended signals and one hundred ohms for differential pairs.
Proper component placement suppresses ringing and overshoots on high-speed digital signals.
Stub Minimization
High-frequency signal transmission across printed circuit board assemblies requires physical proximity between termination components and receiver pins. Placing a termination resistor distant from line endpoints creates stub inductances that generate high-frequency impedance discontinuities. Surface-mount resistor packages placed directly on component pads minimize parasitic trace inductance and stub capacitance.
Parallel termination configurations connect resistors to reference power or ground planes, requiring thermal relief pads to facilitate wave soldering. Series termination resistors placed near driver outputs absorb energy reflected from high-impedance receiver inputs. Automated optical inspection tools confirm component placement alignment and solder fillet shapes on surface-mount pads.
High-density designs integrate thin-film embedded termination elements within PCB substrate layers to eliminate external package parasitics.
Dissipation Penalty
Continuous power consumption increases when low-resistance matching components connect across active signal lines. Parallel termination resistor configurations draw steady-state DC current from output drivers, increasing overall thermal power dissipation across circuit board assemblies. Thermal design evaluations model power plane heat dissipation around termination networks.
Circuit acceptance standards govern maximum allowable package thermal stress.