Electrochemical Property
Plating bath efficiency determines the ability of an electrolytic solution to deposit metal uniformly across a surface with complex geometries. High thrown power ensures that copper reaches the center of a high-aspect-ratio through-hole at nearly the same rate as the outer pads. This property is governed by the conductivity of the electrolyte and the kinetics of the deposition reaction.
Plating Distribution
Solutions with low thrown power tend to deposit thick copper at the corners of the hole while leaving the center walls thin and vulnerable to failure. Maintaining the correct ratio of copper sulfate to sulfuric acid is essential for optimizing this distribution. Additives such as suppressors and accelerators further refine the current density profile across the panel to ensure that the plating thickness is as even as possible.
If the thrown power is insufficient, the board will suffer from barrel cracking during thermal stress. Fabricators adjust the current waveform to improve the penetration of the ions into the deepest recesses of the circuit.
Performance Metric
Aspect ratio limits for a given chemistry are defined by the point where the thickness at the hole center drops below a set percentage of the surface thickness. This value is checked via cross-section.