Wave Propagation
Signal speed refers to the rate at which the phase of a monochromatic wave moves through a transmission line. Calculating the transmission phase velocity is necessary for matching the lengths of high speed differential pairs on a printed circuit board. This value is always lower than the speed of light in a vacuum because the surrounding dielectric and magnetic materials slow the energy down.
Dielectric Influence
Material properties like the relative permittivity and permeability of the pcb laminate determine how much the signal is delayed as it travels from the driver to the receiver. A consistent transmission phase velocity ensures that the clock and data signals arrive at the destination at the same time. If the glass fiber orientation or resin content varies across the board, the resulting skew can cause the digital circuit to fail.
Timing Calibration
Measurements of this velocity are performed using a time domain reflectometer or a network analyzer during the validation phase of a new design. The transmission phase velocity provides the data needed to adjust the length of traces during the layout process to meet tight timing requirements. Designers use this information to create serpentine routing patterns that compensate for the different arrival times of signals on inner and outer layers.
If the velocity is not accurately characterized, the setup and hold times for the memory interface will not be met. This failure often results in a board that functions at low speeds but becomes unstable as the clock frequency increases.