Reinforcement Specification
Woven glass fabric reinforcement provides the structural skeleton for high density rigid laminates. The 2116 style is one of the most common glass weights used in the industry. It consists of a plain weave pattern where each warp yarn passes over and under each fill yarn.
This specific weave uses yarn counts that result in a nominal thickness of 0.0037 inches or 0.094 millimeters when measured before resin saturation. Designers select this weight when they require a balance between mechanical stiffness and overall dielectric thickness.
Dielectric Control
Dielectric control in multilayer boards depends heavily on the spacing between copper planes. Choosing a 2116 style glass ensures a consistent separation of roughly 4 to 5 mils once the prepreg is fully cured. The physical stability of this medium weight fabric resists movement during the high pressure lamination cycle.
Thinner glass styles often suffer from excessive resin squeeze out. This cloth maintains enough glass volume to prevent the conductors from shifting or shorting. It provides a sturdier foundation for blind via landing pads than lighter fabrics.
This fabric is preferred for mid range layer counts where stackup height is not the primary constraint.
Resin Saturation
Resin saturation levels in the glass determine the final bonding strength. A 2116 style fabric typically supports resin contents between 45 and 55 percent by weight. Lower resin percentages might lead to insufficient filling of internal copper patterns.
This fabric is the primary carrier for the epoxy system.