Register Operation
Serial data movement through a chain of registers allows for the observation and control of individual pins on an integrated circuit without physical probe access. The boundary cell shift occurs during the SHIFT-DR state of the JTAG state machine when data moves one position closer to the output. This mechanism enables the transport of test vectors from the controller to the specific pins of every device on a scan path.
Clock Synchronicity
Precise timing of the test clock signal governs the reliability of data transfer between adjacent cells in a scan chain. If a boundary cell shift happens out of sync with the rising or falling edge of the clock, the data bit might be lost or corrupted. Most IEEE 1149.1 compliant devices use a master slave flip flop arrangement to ensure that the bit captured at the pin does not interfere with the bit being moved through the scan path.
Edge transitions must be clean and free of ringing to prevent multiple clocking events within a single cycle.
Signal Integrity
Long scan chains increase the total time required to perform a full interconnect test because every bit must pass through every register. Excessive noise on the TCK line can cause a premature boundary cell shift that offsets the entire pattern. Testing stops.
This error renders the test results useless because the software interprets the shifted bits as incorrect logic levels on the wrong pins.