Tooling Defect
Material degradation occurs on the internal surfaces of an injection mold due to the abrasive or corrosive action of the resin flow. Continuous exposure to high pressure melt leads to cavity erosion, which alters the physical dimensions of the molded part over time. The loss of tool steel primarily affects sharp corners or gates where the velocity of the plastic is highest.
Surface Wear
Abrasive fillers such as glass fibers or mineral powders accelerate the removal of metal from the mold walls. When the protective coating or the tool steel itself wears away, the molded components begin to show dimensional drift or surface defects. Flash often develops at the parting line because the tight seal of the cavity is no longer maintained.
Tooling Longevity
Regular inspection and maintenance of the mold surfaces prevent catastrophic failure of the tooling during high volume production runs. Measurement of critical dimensions on the finished parts serves to identify when the erosion has exceeded acceptable tolerances and requires intervention. Hardened steels or specialized platings mitigate the rate of wear, although they do not eliminate the process entirely over millions of cycles.
When the degradation becomes visible on the surface finish of the plastic part, the cavity must be polished or reworked to restore the original geometry. The frequency of this maintenance depends on the glass content of the resin and the injection pressure settings used by the operator.