Signal Interface
Specialized contact pin designed for high frequency testing facilitates electrical connection to small pads or vias on a printed circuit board. Using an electric stub probe allows a technician to capture signals without permanently soldering a wire to the trace. These devices are common in signal integrity labs where impedance and crosstalk must be measured at specific nodes.
They typically feature a very short ground path to minimize inductance.
Contact Mechanism
Mechanical pressure ensures that the sharp tip pierces any oxidation or residue on the test point. Using an electric stub probe requires a stable contact to prevent fluctuations in the measured waveform. Probe designs often utilize a spring loaded plunger or a compliant cantilever to maintain consistent force during the inspection.
Surface damage to delicate finishes like immersion silver or gold is prevented by this controlled pressure.
Impedance Impact
Electrical length of the probing assembly determines the highest frequency that can be accurately observed. If the electric stub probe is too long, it acts as a capacitive load that distorts the high speed signals of the circuit. This loading effect creates reflections that might be mistaken for board design flaws.
High performance versions are engineered to match the fifty ohm environment of modern digital buses.