Constraint Setting
Restricting degrees of freedom at specific geometric nodes in a structural simulation establishes the mathematical baseline for mechanical stress calculations. In printed circuit board thermal and mechanical modeling, a finite element boundary dictates where the assembly is fixed or supported during simulated reflow or ICT fixture clamping. Applying inappropriate boundary conditions distorts predicted strain distributions across surface-mount component leads.
Verification against strain gauge measurements validates boundary stiffness values before full assembly stress analysis.
Discretization Domain
Spatial partitioning of the circuit board sub-element geometry converts continuous mechanical properties into discrete matrix equations. Mesh density near solder joints and component corners determines calculation accuracy for local stress concentrations. Finite element boundary nodes require fine mesh resolution where rigid pins constrain copper-clad laminate bending during thermal cycling.
Inadequate meshing across thin dielectrics yields underreported von Mises stress figures during drop simulation.
Deformation Load
Applying mechanical loads or thermal fields across nodal boundaries generates reaction forces throughout the simulated board geometry. Differential thermal expansion between dielectric substrate layers and silicon packages imposes cyclic bending strains at the solder ball interface. Finite element boundary definitions must incorporate pin supports and edge guides to mimic physical enclosure fixtures accurately.
Failure to model realistic support stiffness leads to invalid strain gradient outputs that misrepresent joint fatigue life. Modal analysis relies on accurate mass and boundary constraint inputs to predict resonant frequencies during vibration testing.