Impedance State
Test instruction decoders defined in IEEE 1149.1 set all digital functional output drivers of a boundary-scan device into an inactive, high-impedance condition. The highz instruction selects the single-bit bypass register between test data in and test data out, detaching the parallel boundary-scan chain from data routing. Tri-state output drivers effectively disconnect from circuit nets, eliminating output drive currents and suppressing contention with external stimulus equipment.
Functional pull-up or pull-down terminations govern bus voltages during this state. Signal pins floating without pull devices drift toward intermediate logic levels. The command prevents bus contention during automated in-circuit test routines.
In-Circuit Execution
Boundary test execution initiates the high-impedance mode by loading the corresponding bit sequence into the instruction register during the shift-IR controller phase. Output buffers decouple during the update-IR transition, allowing bed-of-nails test fixtures to apply arbitrary voltage levels to connected board nets without damaging output stages. Testing backplane buses or shared memory interconnects requires setting peripheral devices into this passive mode, ensuring external drivers exercise specific net segments cleanly.
Power distribution networks experience reduced current draw as multiple high-power drivers cease switching. Floating lines require pull resistors to avoid unexpected digital switching noise.
Isolation Limit
Operational boundaries confine high-impedance isolation to digital drivers and directional input-output buffers, leaving specialized analog pins and dedicated power rails fully connected to board circuitry. Active termination structures or internal weak pull-up resistors may continue sourcing current unless explicitly disabled through hardware configuration pins. Functional testing cannot measure receiver thresholds while drivers float without coordinated external bias sources.
Board-level validation verifies that no intermediate logic voltages trigger destructive latch-up across adjacent CMOS inputs. Unintended signal float damages unprotected high-gain receiver inputs.