Mount Examination
Standardized laboratory microsectioning establishes destructive physical analysis procedures to evaluate internal features within rigid, flexible and multi-layer printed boards. Governed by the test criteria of IPC-TM-650 method 2.1.1, technician preparation protocols extract precision coupon samples, mount the extracted segments in thermosetting resin and grind the metallographic plane to expose plated through-holes. The resulting cross-section permits direct microscopic measurement of plating thickness, dielectric spacing, copper foil thickness and internal layer registration.
Production lot acceptance hinges on these optical determinations, ensuring that barrel plating, knee coverage and foil adhesion satisfy purchase specifications.
Specimen Preparation
Coupon excision isolates representative through-hole barrels using diamond abrasive saws operated under constant liquid cooling to prevent thermal distortion of the resin matrix. Under the procedural rules of IPC-TM-650 method 2.1.1, the technician grinds the encapsulated specimen down to the precise diametral centre of the target hole row, employing silicon carbide papers of progressively finer grit sizes. Subsequent polishing steps with diamond or alumina suspensions remove surface scratches, leaving a mirror finish that prevents optical distortion under high-magnification metallurgical microscopes.
Chemical etching follows polishing to delineate grain boundaries between electroplated copper, laminate foils and solder deposits. Cross-sectional microsections reveal defects such as copper barrel cracking, resin recession, inner layer separation and plating nodules. Visual confirmation of barrel voids provides the legal verification required for rejecting non-compliant fabrication panels during arm’s length quality audits.
Class 3 high-reliability product lots demand rigorous adherence to these grinding steps to expose uncompromised annular ring alignments.
Acceptance Limit
Over-polishing past the central axis of the through-hole invalidates the entire measurement series by artificially inflating measured plating thicknesses. If abrasive preparation creates edge rounding along copper boundaries, optical focus drifts across the interface and yields erroneous readings for out-of-round hole features. Qualified receiving inspections disqualify microsections exhibiting preparation-induced cracks or resin smear across foil interfaces.