Resin Flow
Resin flow into sub-layer clearance gaps during press cycles prevents internal voiding in multilayer circuit boards. Complete encapsulation of internal copper features during thermal curing establishes lamination prepreg fill. Pressure profiles and resin gel time determine mechanical flow into internal copper clearance areas.
Dielectric layer glass transition temperature establishes the thermal boundary where resin viscosity drops to minimum levels.
Pressure Profile
Vacuum hydraulic presses apply controlled thermal cycles to drive liquid resin into deep pattern topography. Inadequate pressure during the liquid phase leaves micro-voids between adjacent copper traces. Excessive vacuum pressure strips resin from glass fibers, causing weave exposure and dielectric breakdown.
High copper foil weight creates deep pattern relief that requires high resin content prepreg styles to prevent resin starvation. Vacuum extraction removes trapped air and moisture volatiles before resin gelation locks the structural matrix. Rheological properties of epoxy resin govern melt viscosity changes throughout the lamination heat cycle.
Heating rates must align with resin gel kinetics to permit complete air evacuation before solid curing begins.
Void Inspection
C-mode scanning acoustic microscopy detects un-filled internal cavities without destroying test samples. Microsection analysis confirms resin penetration around high-density inner layer pattern features. Incomplete lamination prepreg fill causes internal delamination and thermal stress failure during assembly reflow cycles.