Consignment Verification Process
Formal evaluation protocols govern the systematic inspection, testing and statistical sampling of a finished manufacturing batch to establish whether the collective volume satisfies contractual baseline specifications. Within board fabrication and electronic assembly procurement, lot acceptance functions as the operational quality gate executed prior to formal title transfer and payment settlement between buyer and supplier. The scope of this process is strictly confined to verifying conformity within a defined production batch, terminating once the lot is released or rejected.
It relies on non-destructive examinations and destructive coupon analysis rather than continuous line monitoring.
Sampling Mechanics
Sampling procedures conform to statistical frameworks, including ANSI/ASQ Z1.4 and ISO 2859-1, defining precise sample counts extracted at random from delivered quantities based on defined acceptable quality levels. Evaluators submit companion test coupons, produced on the perimeter of production panels, to thermal stress testing, micro-sectioning and copper tensile verification. Inspectors perform dimensional verification, warpage measurement and surface finish thickness checks using X-ray fluorescence instrumentation.
Bare boards encounter automated continuity testing, insulation resistance screening and solderability evaluations. Assemblies face automated optical inspection along with random functional verification.
Disposition Decisions
Inspection results determine the binary disposition of the entire production consignment. If defects found within the inspected sample set surpass predetermined acceptance numbers, the entire lot faces total rejection or complete sorting at supplier expense. Concessions or material review board variances can permit conditional release only under documented engineering review.
Rework provisions outlined in IPC standards govern whether rejected lots may undergo strip-and-replate cycles, thermal baking or component resoldering before entering re-inspection. A single uncorrected structural failure in a cross-section coupon, such as inner-layer barrel separation, triggers lot rejection to protect downstream assembly yields.