Signal Phenomenon
Frequency dependent variation in the effective permittivity of a transmission line causes different spectral components of a signal to travel at different velocities. High speed digital designs must account for microstrip dispersion to prevent the degradation of pulse shapes over long distances. The change occurs because the electromagnetic field distribution shifts between the air and the dielectric substrate as the frequency increases.
Velocity Distortion
Pulse broadening happens when the high frequency harmonics of a square wave move slower than the fundamental frequency. Engineers observe that microstrip dispersion leads to inter-symbol interference, where the tail of one bit overlaps the start of the next bit. This effect becomes pronounced at data rates exceeding 10 gigabits per second or when the dielectric thickness is a large fraction of the wavelength.
Reducing the height of the substrate or choosing a material with a lower dielectric constant can mitigate the timing jitter caused by this shift.
Design Threshold
Calculations for characteristic impedance that ignore the change in effective permittivity will produce errors in narrow strip widths at millimeter wave frequencies. A microstrip dispersion model must be used in the simulation phase to ensure that the arrival times of parallel signals remain synchronized. Frequency impact is most severe on thick laminates where the field is less confined to the region directly beneath the conductor.
Fabrication tolerances in the copper etching process can further complicate the prediction of these phase velocity changes.