Lamination Equipment
Industrial thermal-hydraulic press machinery featuring stacked horizontal heating platens contained within an evacuatable enclosure executes the consolidated curing of multiple panels of multi-layer printed circuit boards. The multi-opening vacuum press operates inside PCB fabrication facilities to melt, flow and crosslink thermosetting prepreg resins under simultaneous mechanical pressure, elevated temperature and deep sub-atmospheric vacuum. Platens heated by recirculating thermal oil, pressurized steam or electrical resistance elements transfer thermal energy into sandwiched book assemblies separated by steel separator plates.
The operational scope covers the multi-layer lamination stage of core and prepreg bonding, stopping short of outerlayer surface finishing, drilling or downstream component assembly.
Mechanical Operation
Lamination runs proceed through sequential physical stages designed to extract volatile gasses before initiating polymer crosslinking. Operators load multiple carrier cassettes into separate platen openings, each cassette holding several multi-layer panel books insulated by release films, stainless steel divider plates and thermal cushioning pads. Sealing doors isolate the hydraulic chamber, where mechanical vacuum pumps evacuate the internal environment to pressures below thirty millibars, extracting trapped air and residual moisture from prepreg glass bundles.
Hydraulic cylinders drive the stacked platens upward, transferring compressive loads between two hundred and three hundred fifty pounds per square inch across the entire surface area. Internal platen sensors control thermal ramp rates between two and three degrees Celsius per minute, guiding epoxy or polyimide matrices through their minimum melt viscosity window. Controlled fluid resin fills innerlayer copper clearance relief holes and embeds etched conductor edges before the polymer crosslinks into an infusible solid.
Coordinated hydraulic valves modulate pressure during the cure dwell to prevent resin starvation and control finished board dielectric thickness.
Fabrication Consequence
Process precision across every opening controls dielectric uniformity across large production batches. Uneven thermal distribution across different platen levels causes localized viscosity variations, generating uneven resin bleed, dielectric thickness deviations and panel warpage. Trapped volatile pockets escape under vacuum pressure, eliminating internal micro-voiding defects that cause catastrophic innerlayer electrical shorts or CAF failure.
Controlled cooling under sustained hydraulic pressure prevents internal mechanical stresses from freezing into the glass matrix, suppressing post-cure panel bow and twist. The multi-opening vacuum press maintains precise board thickness and resin content across high-layer-count backplane and high density interconnect panels.