Timing Instability
Voltage stability measurements during transistor switching track the variations in propagation delay for digital signals. Power supply induced jitter appears as a shift in the edge placement of a clock or data stream. When the supply voltage drops, the transistors in the signal path switch more slowly.
This dependency creates a direct link between the noise on the power rail and the timing uncertainty of the high speed interface.
Impact Analysis
Total jitter in a system is the sum of random and deterministic components, where supply noise contributes to the latter. High speed serial links have narrow timing margins that can be consumed by even small amounts of supply ripple. If the jitter exceeds the eye opening of the receiver, the bit error rate increases considerably.
Measurements usually involve correlating the frequency spectrum of the power supply noise with the jitter spectrum of the clock.
Circuit Design
Low dropout regulators with high power supply rejection ratios provide a clean voltage source for sensitive clock generation circuits. Adding a local filter composed of an inductor and a capacitor further isolates the device from high frequency transients. Designers also use differential logic styles that are naturally less sensitive to common mode voltage variations on the rails.
Verification requires stressed timing tests while the power network is subjected to simulated load transients.