Signal Transmission
A high-speed routing structure consisting of two complementary copper conductors transmits digital data with low noise and high noise immunity across printed circuit boards. Utilizing serdes differential pairs allows for serialized high-bandwidth data transfers over long physical runs by comparing the voltage difference between the two tracks. This technique minimizes the emission of electromagnetic interference and rejects common-mode noise coupled from neighboring circuit traces.
Layout Geometry
Layout designers must maintain tight coupling between the two traces to preserve the target differential impedance, which is typically ninety or one hundred ohms. For serdes differential pairs, trace width, trace spacing, and the dielectric height of the laminate must remain uniform along the entire length of the signal path. If the two lines diverge to navigate around obstacles like mounting holes or mounting screws, the differential impedance changes abruptly, causing signal degradation.
Traces must also be matched in length to prevent phase skew, where the signals arrive at different times and distort the received eye diagram.
Discontinuity Management
Transitions between board layers using plated through-hole vias introduce impedance mismatches that must be mitigated by adding return-path ground vias adjacent to the signal vias. These ground vias maintain a continuous current path and prevent signal degradation at multi-gigabit data rates.