Out-of-plane Measurement
Optical metrology provides non-contact surface topography analysis through projected light patterns. Shadow moire interferometry maps deviations in circuit board flatness by placing a reference grating close to the substrate and illuminating it at an angle. The resulting interference fringes reveal vertical displacement as a function of the pitch and geometry of the grating.
This method identifies warpage in printed circuit boards and electronic packages during thermal cycling or reflow simulations.
Process Verification
Fabricators use this non-destructive technique to validate mechanical integrity following high temperature exposure. Deviation from a flat plane influences soldering success because coplanarity governs the contact between leads and pads. A light source hits the grating at a set angle to produce a shadow on the component surface, which interacts with the physical grating to generate visible fringes.
Practitioners calibrate the fringe density against the known grating geometry to extract absolute height values at any location across the board area. Precise height resolution depends upon the angle of illumination and the period of the grating lines. Higher sensitivity occurs when the angle increases or the grating pitch decreases.
Surface Constraints
Thermal expansion coefficients of distinct materials generate internal stress during cooling, leading to permanent deformation. This interferometric approach detects bowing or twisting that exceeds design tolerances before assembly occurs. Automated systems perform these measurements across entire board surfaces to ensure conformance with standards regarding planarity.
High resolution topographic maps offer quantitative data for engineering analysis of structural failure modes. Validated flatness data prevents connectivity issues caused by mismatched component-to-pad alignment.