Etching Erosion
Lateral chemical dissolution of copper foil beneath the protective photoresist boundary creates a trapezoidal deviation along the conductor cross-section. The presence of side edge undercut reduces the top width of a conductor relative to its designed base dimension, establishing an etch factor ratio that governs trace geometry fidelity. This lateral attack halts when the panel leaves the chemical etching chamber and enters the acid neutralization and rinse stages.
Erosion Dynamics
Acidic cupric chloride or alkaline spray solutions etch downward through exposed copper foils while simultaneously dissolving metal horizontally under the resist mask. Spray pressure and chemical replenishment rates accelerate side edge undercut along outer trace corners. Thicker copper foils experience longer dwell times in the spray chamber, which magnifies lateral metal loss.
Differential etching rates along top and bottom foil boundaries yield angled conductor sidewalls. Optical microscopes measure this phenomenon via polished metallurgical cross sections extracted from fabrication quality coupons.
Impedance Impact
Uncontrolled lateral etching narrows the upper surface area of conductive tracks, reducing intended high-frequency cross-sectional conductor volume. Severe undercut shifts characteristic trace impedance above nominal customer specifications, triggering electrical test failures during batch quality lot screening. Front-end engineering CAM software applies etch compensation factors to pad and track widths to counteract predictable lateral dissolution.
Excessive undercut causes thin resist overhang, which breaks off into flakes that create short circuits between fine-pitch conductors. Side edge undercut defines the minimum track and space design rules achievable on subtractive printed circuit board fabrication lines.