Etch Factor
Chemical milling removes metal anisotropically during printed circuit board fabrication, creating sidewall undercut when etchant eats laterally beneath the resist mask. This horizontal attack reduces conductor width at the trace top compared to the base, forming a trapezoidal cross section instead of vertical walls. Liquid etchant dynamics dictate that fresh chemistry reaches the upper trace edges faster than the trapped floor boundaries.
Process engineers measure this geometric deviation against the vertical height removed to establish the etch factor ratio. Controlling bath temperature, spray pressure, and cupric chloride concentration minimizes horizontal erosion during heavy copper reductions.
Trace Geometry
Automated optical inspection systems detect sidewall undercut by evaluating light scatter profiles along conductor edges after etching. Excessive lateral loss compromises current carrying capacity and impedance stability in high frequency circuit designs. Etched conductors must maintain minimum copper thickness at the trace edge to satisfy IPC acceptance standards for class three electronics.
Circuit board manufacturers adjust line compensation values on phototools to counteract expected lateral etching losses before production runs begin.
Cross Sectioning
Microsection analysis provides destructive verification of sidewall undercut by polishing embedded laminate samples to expose internal copper traces under magnification. Metallurgical microscopes measure the difference between top resist width and bottom copper width to calculate exact anisotropic etch ratios. Production lines use these physical measurements to adjust conveyor speeds in horizontal spray etchers.
Uncontrolled chemical exposure weakens adhesion at the copper laminate interface during subsequent multilayer lamination cycles.