Workmanship Defect
Small spheres of metal that detach from the primary joint during reflow soldering sit loosely on the board surface or solder mask. In printed circuit board assembly, solder balls represent a severe defect that can cause electronic system failure. These isolated spheres occur when solder paste escapes the pad boundaries or fails to coalesce into the central molten pool.
Thermal Root
Rapid heating during the preheat phase of the reflow oven is the primary driver of this particle separation. If the solvent in the solder paste boils too quickly, it explodes and scatters tiny metal particles across the board surface. Moist laminates or poorly stored pastes exacerbate this effect because the expanding moisture physically expels the solder particles from the main joint area.
Poor stencil alignment during paste printing can also leave tiny deposits on the mask that later form these spheres during heating, bridging fine-pitch conductors.
Process Adjustment
Optimizing the reflow temperature profile by establishing a gentler thermal gradient reduces the risk of solvent spattering. Stencil cleaning cycles must be programmed to wipe the underside of the foil regularly, preventing the transfer of excess paste to the board. Post-reflow visual inspection using automated machines identifies and registers these defects for manual rework or automatic board rejection.