Structural Deflection
Physical distortion of a printed circuit board caused by non-uniform temperature distribution across its surface or thickness. During the reflow soldering process, thermal gradient bending occurs when one side of the board expands more rapidly than the other. This differential expansion forces the laminate to curve, which can lead to solder joint failures.
It is a common challenge in large, thick backplanes or boards with heavy copper loads.
Defect Mechanism
Induced Stress. The internal stresses created by the temperature difference can pull components away from their pads before the solder solidifies. When thermal gradient bending is severe, the resulting distortion causes open circuits or head-in-pillow defects on ball grid array packages.
The degree of curvature depends on the glass transition temperature of the resin and the orientation of the glass fabric. Preheating the board more slowly can reduce the severity of these gradients.
Process Control
Mitigation Strategy. Assembly engineers use carrier pallets or rigid fixtures to hold the board flat as it passes through the oven. Monitoring the delta-T between the top and bottom of the assembly allows for more precise profiling of the reflow zones.
Minimizing thermal gradient bending ensures that the coplanarity of the board remains within the tolerance of the solder paste deposit. Boards that remain flat through the entire cycle exhibit higher long-term reliability.