Cross-sectional Morphology
A non-rectangular trace geometry arises from the anisotropic action of chemical etchants during copper removal. This resulting shape, known as a trapezoid conductor profile, features a wider base at the bottom dielectric surface than at the top. It influences both the cross-sectional area and the surface trace spacing of high-speed digital lines.
This geometric shape modifies the electrical parameters of the printed board traces.
Etch Factor
As the liquid etchant is sprayed onto the copper laminate, the chemistry dissolves the top of the copper feature for a longer duration than the bottom. This differential exposure creates a sloped sidewall rather than a straight vertical wall. The slope angle is a function of the etchant type, spray pressure, and the initial thickness of the copper cladding.
When calculating the resistance and capacitance of these features, a simple rectangular model will produce large errors. Designers use a modified etch factor equation that incorporates the trapezoid conductor profile to calculate the correct characteristic impedance. This calculation is particularly critical for differential pairs where the spacing between the sloped sidewalls affects the differential mode coupling.
Impedance Deviation
High-magnification micro-sections of finished test coupons are measured to verify the actual trace geometry against the simulation models. Adjusting the spray parameters on the etching line helps to minimize the slope and make the profile closer to a rectangle. The resulting data helps designers optimize the nominal trace widths to hit target impedance tolerances.