Radiation Deviation
Angular deviation in the main lobe of a phased array antenna occurs when the signal frequency shifts away from the design center. This frequency-dependent deflection, known as beam squint, alters the pointing direction of the transmitted signal without any change in the physical orientation of the board. The phenomenon is particularly pronounced in microstrip patch arrays where the transmission lines are printed on high-frequency laminates.
Fabricating Factor
Local variations in the dielectric constant of the laminate represent the primary manufacturing driver of this performance defect. If the glass-to-resin ratio fluctuates across the panel during pressing, the phase velocity of the RF signal changes along the feed networks. Etching tolerances also contribute, as narrow or over-etched microstrip lines modify the trace impedance and introduce phase errors across the feed paths.
Control of the dielectric thickness and copper line profiles during the plating process is therefore necessary to keep these phase variations within design limits. When boards are fabricated in multi-up panels, board-to-board variation must be minimized so that high-volume assembly runs yield consistent antenna behavior across all modules. Fluctuations in the copper surface roughness at the substrate interface can also alter the effective phase velocity, making low-profile copper foils the preferred choice for these applications.
Testing Protocol
Vector network analyzer measurements of the feed network phase distribution identify the board-level variance before final module assembly. High-frequency boards are inspected using specialized probe fixtures that capture the insertion loss and phase angle of each branch of the feed network. If the phase error exceeds a specified tolerance angle, the board is rejected to avoid degradation in the antenna directivity.
These measurements ensure that the final phased array meets its directionality requirements without needing expensive individual digital calibration.