Transient Measurement
Real-time measurement of mechanical deformation during assembly operations captures the physical forces acting on circuit card assemblies. In-situ dynamic strain testing uses surface-mounted resistance gauges to record transient stress spikes during routing, panel separation and screw attachment. This test method provides a continuous stream of microstrain values that prevent overstressing fragile ceramic capacitors and solder joints.
It establishes a quantitative trace of the mechanical stress history for each step of the manufacturing sequence.
Stress Analysis
Deflection rates and maximum strain values are plotted against established limits to identify operations that exceed material tolerances. High-speed recording instruments log the data at sample rates exceeding fifty kilohertz to capture rapid impact events. When these transient peaks are matched to specific assembly actions, the source of board bending is isolated and corrected.
This isolation allows engineers to modify fixture clamping forces or alter the path of a routing tool before a whole batch of boards is damaged.
Laminate Acceptance
Acceptance criteria from industry standards dictate the maximum allowable strain based on board thickness and component size. Solder joints on larger chips fail at lower strain values than those on smaller chips. Placing sensors near the most sensitive components ensures that the measured strain accurately represents the worst-case mechanical exposure during testing.