Plating Balance
Electrochemical deposition of copper onto printed circuit board surfaces and through-hole walls depends on the rate of electrical charge delivered per unit area. Achieving the proper electrodeposition current density ensures a uniform metal thickness is achieved across the entire panel. Low rates result in thin copper on hole walls, while excessively high rates cause rough, nodular copper deposits at the knee of the hole.
This parameter limits the speed at which a plating line can run.
Deposition Distribution
Panel geometry and the spacing of circuit features influence the local electrical field strength during the plating cycle. When the electrodeposition current density is uneven, isolated traces receive a high concentration of current, leading to over-plating and subsequent etching difficulties. Conversely, dense trace areas receive less current, which results in thin copper layers that fail minimum thickness standards.
Plating engineers use dummy pads or thief traces on the panel border to redistribute the current more evenly. This shielding prevents uneven metal distribution across the active board surface and ensures that fine traces remain within impedance specifications.
Process Monitoring
Continuous monitoring of the electrical current and rectifier output is required to maintain consistent copper quality. Automated power supplies adjust the current to match the calculated surface area of the panels in the tank, ensuring the target electrodeposition current density is maintained. Microsectioning of processed boards confirms the copper thickness meets requirements.
This inspection prevents defective panels from reaching the assembly floor.