Material Distortion
Multilayer printed circuit board fabrication subjects thin copper-clad laminates to high temperature and pressure during the pressing cycle. This process triggers inner layer dimensional movement, which is the physical expansion or contraction of the laminate material after the copper foil has been etched and the layers have been heated. Because laminate resins have different thermal properties than copper, the removal of copper during circuit imaging causes the remaining material to shift in dimension.
Scale factors are applied to the artwork during the tooling phase to compensate for this expected shift.
Registration Accuracy
Mismatches between the positions of inner layer pads and drilled holes can result if the material shifts unpredictably. When the inner layer dimensional movement exceeds the design tolerance, the drill bit may not strike the center of the inner pad, leading to partial or complete electrical open circuits. Resin selection and grain direction of the reinforcing glass cloth are managed during manufacturing to ensure the movement remains consistent and within limits.
Artwork Compensation
Pre-production test runs establish the specific shrinkage and expansion rates of each laminate type. This database of movement coefficients allows engineers to scale the imaging masks and ensure precise drill-to-pad alignment on every layer.