Testing Standard
Moisture susceptibility evaluation for multilayer printed boards represents a primary quality check for high-reliability electronics. Conformity to ipc-tm-650 2.6.16 determines whether a laminate can withstand exposure to high humidity followed by thermal shock without experiencing internal delamination. The test method is widely used by board fabricators to validate the curing quality of the resin and the bond strength between copper and prepreg layers.
Laboratory Procedure
Test specimens are first subjected to a bake-out cycle to remove all residual moisture before being placed in a pressurized steam chamber. This exposure to high-pressure steam drives water molecules deep into the resin matrix and along the glass fibers of the substrate. After a specified exposure duration, the samples are dipped into a molten solder bath to simulate the intense thermal stress of reflow assembly.
Operators then inspect the boards under magnification to check for the presence of blisters, resin recession, or copper-foil separation.
Failure Mechanism
Interfacial adhesion failure between the glass-reinforced epoxy and the copper foil typically occurs when moisture vaporizes rapidly during the solder-dip phase. If the chemical treatment of the copper surfaces was inadequate or the lamination cure was incomplete, the localized pressure of the expanding steam tears the material layers apart. This testing protocol prevents boards with latent adhesion defects from entering the high-volume assembly stage where failure would lead to catastrophic field returns.
Multilayer boards must pass this test without any signs of delamination to be accepted under IPC Class 3 standards. By establishing a rigorous baseline for lamination performance, the standard helps manufacturers adjust their lamination parameters, such as press temperature and dwell time, to achieve a fully cured laminate matrix.