Flow Restriction
The minimum cross-sectional area within a fluid delivery orifice controls mass flow rate and fluid velocity in automated liquid dispensing equipment. Inside a precision dispensing tip, the nozzle throat acts as the primary hydraulic resistance element governing fluid delivery volume per pulse. Diameter tolerances held within two micrometers ensure repeatable volumetric deposition of liquid underfill, solder paste, and conformal coating.
Fluid velocity reaches its maximum value within this narrow passage, generating high shear rates that temporarily reduce viscosity in pseudoplastic materials.
Pressure Drop
Hydraulic pressure drop across the internal restriction determines dispensing cycle time and fluid jet formation during non-contact jetting operations. Fluid compressibility and viscous heating inside the nozzle throat cause temperature rises that alter dispensing rheology if duty cycles are excessive. In automated board assembly, small throat diameters prevent tailing and stringing of high-viscosity encapsulants between component pads.
Accumulation of cured resin or dried filler particles inside the internal diameter restricts fluid passage, raising backpressure and causing volumetric under-dispensing. Regular purge cycles with compatible solvents prevent particle agglomeration and maintain consistent dispensing geometry across long production shifts.
Deposition Tolerance
Volumetric accuracy of jetting valves depends directly on maintaining stable internal dimensions against mechanical wear from abrasive solder paste filler particles. Diameter enlargement of five percent increases volume throughput by over twenty percent, causing solder bridging defects.