Insulating Material
Polymer coatings that react to ultraviolet light allow for the creation of precise microvia patterns without the need for mechanical or laser drilling. The application of photo imageable dielectric creates a thin insulating layer that can be patterned using standard photolithography equipment. Patterned insulation is essential for advanced sequential build-up processes in high density circuit fabrication.
Processing Sequence
Liquid or dry film versions of the material are applied to the substrate and then partially cured. Exposure through a photomask defines the areas where openings will be formed. After developing the photo imageable dielectric in a chemical solution, the remaining material is fully cured to achieve its final mechanical and electrical properties.
This method allows thousands of vias to be formed simultaneously across a large panel. Control of the exposure energy and develop time ensures that the side walls of the microvias are consistent across the entire circuit board.
Design Advantage
Smaller via diameters and tighter pitches become possible because the resolution is limited by the wavelength of light rather than the diameter of a drill bit. Using photo imageable dielectric also results in a flatter surface topology compared to traditional resin systems. This flatness facilitates the registration of subsequent layers in complex stackups.