Hardware Layout
Digital signal lines combining multiple open-emitter or active-high open-drain outputs across a single pull-down resistor implement OR logic without active silicon gates. This configuration, designated as wired-OR, drives the node to a high voltage state if any connected output transistor is turned on. When all driving transistors are inactive, the pull-down resistor forces the common line back to the ground potential.
Microprocessor systems employ this configuration to aggregate active-high error flags or status signals onto a single interrupt trace.
Bus Operation
The passive pull-down resistor must be selected to match the driving capability of the connected transistors and the capacitance of the trace. In a wired-OR configuration, the active turn-on transition is driven directly by the low-impedance transistor, resulting in a rapid rise time. The turn-off transition, however, depends entirely on the RC time constant formed by the pull-down resistor and the total bus capacitance.
This asymmetric switching behavior means the fall time is typically much slower than the rise time, which can restrict the maximum operating frequency of the bus. Using too small a resistor increases the steady-state current and thermal dissipation of the driver chips when the bus is held high. Engineers use transmission line analysis to optimize the resistor values and preserve acceptable signal margins.
Performance Limitations
This layout reduces the overall component count and saves routing space on densely packed printed boards. Devices can be hot-plugged into the bus without risking short circuits or signal contention because no driver can actively pull the line low. This feature is particularly useful for backplanes and expansion slot architectures.
Careful layout prevents crosstalk from adjacent high-speed traces from falsely triggering the sensitive high-state line.