Glass Architecture
Woven glass fabric reinforcement built from fine filament yarns provides thin electrical insulation layers within multilayer printed circuit boards. Uncured 106 prepreg utilizes a very light glass weave pattern impregnated with thermosetting resin to yield nominal uncompressed thicknesses around 33 micrometers. High resin content in this material format supports complete encapsulation of dense copper patterns during vacuum lamination.
Fine filament geometry allows precise microvia drilling without severe glass fiber deflection.
Hydrodynamic Behavior
Viscous resin flow during the thermal press cycle determines how fully internal circuit clearances fill before gelation halts liquid movement. Because 106 prepreg contains a high volumetric ratio of resin to glass fabric, excess liquid resin moves quickly under applied lamination pressure. Hydraulic force drives the fluid matrix across inner layer copper features to eliminate void formation.
Excessive pressure drives resin out of the laminate structure entirely, leaving starved areas near board edges. Lower lamination pressures maintain stable dielectric spacing across tight signal line spacing while preventing resin squeezed from board boundaries. Thermal ramp speed controls the duration of low viscosity state in the press cycle.
Dielectric Limit
Thickness variation across the laminated panel affects characteristic impedance in high frequency signal channels. Thin glass styles like 106 prepreg exhibit mechanical compression under hydraulic pressure, reducing final insulation thickness. Dielectric breakdown voltage decreases when fiber movement creates localized resin starvation during lamination.