Through-Hole Acceptance
Solder penetration height within a plated through-hole relative to the total board thickness defines the vertical wetting success of a joint. Verification occurs during post-soldering inspection. IPC Class 2 products usually require a minimum of 75 percent barrel fill percentage to provide adequate mechanical strength and electrical reliability.
If the molten alloy fails to reach the required height, the joint may suffer from insufficient structural integrity under thermal cycling.
Thermal Management
Heat sinking by internal copper planes often hinders the capillary action required for a complete rise. High copper weights in multilayer designs pull heat away from the barrel, causing the solder to solidify before it reaches the top surface. Adjusting preheat temperatures or slowing the dwell time in the solder wave helps overcome these thermal sinks.
Proper flux application also ensures that the entire internal surface of the barrel remains oxide-free during the soldering event. Thermal profiles must be tuned to keep the alloy fluid until it exits the top of the hole.
Inspection Metric
Non-destructive evaluation of this vertical rise relies on X-ray imaging or cross-sectional analysis. Automated inspection systems measure the density of the solder column against the known board thickness to calculate the resulting ratio. A failure in this metric points to inadequate fluxing or insufficient heat.