Measurement Method
Precision resistance measurement techniques isolate the voltage drop across a component from the resistance of the test leads and contacts. Low ohm testing employs four-point kelvin sensing to achieve milli-ohm accuracy during board level inspection. Two leads carry the source current while a separate pair of leads measures the potential difference.
Current remains constant across the junction while the high impedance of the voltmeter prevents current flow in the sensing leads.
Circuit Implementation
Continuity testing of high current power planes requires this separation of current and voltage paths to detect subtle manufacturing defects. Automated test equipment applies the four-point kelvin sensing probes to specific test points on the finished bare board. By eliminating the lead resistance from the calculation, the tester identifies micro-shorts or thin copper layers that a standard two-wire probe would miss.
This method is standard for verifying the integrity of heavy copper paths in automotive or industrial power modules. Technicians use this data to confirm that the plating thickness in high aspect ratio vias meets the minimum cross sectional area required for the design current.
Accuracy Threshold
Error reduction occurs because the sensing leads do not experience the voltage drop associated with the test current. In a two-wire setup, the resistance of the probe tips and the internal wiring of the meter adds an offset to the result. High precision requirements for low resistance shunts make the four-point kelvin sensing approach mandatory.
Measurements stay stable even when contact pressure varies slightly at the probe point.