Force Application
Mechanical force applied via liquid fluid systems across pressing plates constitutes the primary compaction mechanism in multilayer circuit board lamination processes. Controlled application of hydraulic lamination pressure consolidates glass reinforced prepreg layers with copper foil cladding into rigid planar structures.
Resin Viscosity
Heating cycles inside lamination presses reduce prepreg resin viscosity to a liquid state, allowing hydraulic forces to press air bubbles and volatile gases out of internal layer interfaces. Pressure profiles follow precise ramps, applying low initial tonnage during resin flow phases to prevent excessive resin squeeze-out from panel edges. Once resin polymerization initiates and cross-linking advances, hydraulic systems escalate force to final compaction levels to set exact dielectric thickness.
Uneven pressure distribution across large platen surfaces generates localized thickness variations and internal strain within the fiberglass matrix. Stainless steel caul plates and thermal cushioning pads cushion pressure transfer, mitigating localized stress spikes near high-density copper features. Pressure transducers continuously monitor force across multiple press zones, providing closed-loop feedback to maintain tight tolerance standards throughout the cure cycle.
Void Elimination
Insufficient pressing force leaves unbonded areas known as delamination pockets within cured laminates. Excessive pressure drives out required resin volume, causing glass fiber exposure and short circuits between internal signal layers.